Savic top door

[Ria P]

Originally Posted by Serendipity7000

Wow it's great. I thought you'd do it quickly What is the grey marbled bit round the edge? I thought the plastic frame was clear or white before?

Just out of interest - how did you finish the cut bars? So the dremel has a cutting tool - does it have a metal sanding tool as well - to finish rough edges?

The grey marble effect is just duck tape.

Yes, i have different kind of cutting discs, pvc and metal, for the Dremel. The discs are from B&Q.

I used wire cutters for the thin bars and the Dremel for the thick ones.

I used a Dremel metal file bit to file the end bits down but they are covered by the plastic bit from the door which sits flash against the bars. Kind of sunk into the square i cut out.

I suppose an all wire door panel would be easier to do but i couldn't find a door big enough. Here's a close up.