So Robo is coming tomorrow and his cage set up is finished. Did a bit more tweaking today. There are still a couple of small things in the freezer that will need to be added later (some treat snacks and a dangly loofa thing.
So - it was quite fiddly. Done a bit at a time over the last week and a bit in between other things as it's been a busy week (so the delay has worked in my favour).
Setting up a plaza for a robo there is the height issue.
Have 4" high cardboard around the inside of most of the bars and about 9" of substrate. Which reduces the height a lot. So house is supported on full height legs (and still looks low!). The rock thing is resin and quite light, but sat on a platform anyway as quite big so would still weigh a bit. The platform underneath is the my hack platform made from Pickle's old house - it also has dowel legs glued to it so supported underneath.
It's all Fitch but a bit of Finacard sprinkled on top and a few cornflower petals.
So I got it all set up eventually after missing screws and wingnuts for various shelves - found the screws eventually. And the ladder well and truly secure. Glued a dowel to the shelf but it could still lift up so OH drilled a hole in the side and I screwed that to the bars as well.
Attachment 52585
Attachment 52586
Attachment 52587
Attachment 52588
Attachment 52589