I've mentioned before that I was making a hamster cage for my A level product design coursework. Now that I've got most of my exams out of the way I thought it might be a good time to show you the final thing.
I'm not too happy with it. If I hadn't had to stick to the deadline I would definitely taken a lot more time to make it perfect but I guess it's alright.
I fixed the issue of the lid leaving a bit of a gap where there is the partition for the storage area which you can see in some of the photos. I used Ponal glue and did two coats of plastikote on every surface. Thinking about doing the inside surfaces another time just to make sure.
https://imgur.com/gallery/ZbBSX40
Sadly it will be september/ october by the time I can bring it home but when I do I think I'll do some other improvements so if you have any suggestions feel free to reply with them