Re: Photo Guide to Making a Bin Cage
I am just in the process of making my first of 6 bin cages. I used the soldering iron to cu the whole. My question is, On the inside the soldering iron made the plastic kind of bumpy, so its not flat there's a lip. Should I use some sand paper to smooth it out or will it be ok. My Sammy is trying very very hard to break out of the cage he is in now although I can't blame him, he is a pretty big Syrian and the cage is kind of small but the biggest one they had at petsmart for hamsters. So, are these pretty hard to break out of if I am careful to tie everything down tight?
|
Threaded Mode