It is 1m 23 cm x 38 high x 37 deep its not as deep as I'd of liked but its longer than I planned to make it when I was going to buy the stuff but father inlaw had loads of contiboard spare (so far it's cost nothing. The bedding stoppers are too big so I will be making them a little thinner and toys for the cage with a digging box in each level, one will be for my syrian and one for the two rc's will be covering the inside with pvc and siliconing all internal edges tomorrow
Last edited by 8piggie3hammies; 06-01-2011 at 01:48 AM.
Hooray for home made cages! Bet the hams will love them!
__________________
Welcome, my handsome LH syrian boy Dr Calcifer Lightman (a.k.a "Cal")!
Run free at the bridge my precious little Senpop. (10/10 - 04/12)
RIP My sweet little dwarfies - Doc and Noodle <3
Looks great so far, just make sure, that there's enough ventilation xD
At each side there should be a 20x20 cm big hole covered with mesh or something similar.
There won't be anything on the front's it will be open the dwarf's are in a open cage now anyway thebedding stopper's are lower now too but my syrian can get out so i will be putting a wire mesh door on the bottom cage
I have started making my hamster habitat
x
Bet the hams will love them!
Linear Mode
