Amethyst_ice
04-26-2010, 05:57 AM
Ok so i have finally got Gizmo's furplast tube extension piece and some tubes. The tubes were about a few mm too small so they fit in but didn't stay very sturdy so superglue came in handy there and worked fine :)
The new cage is all set up and now i just have to attach the piece to his wire cage.
Problem is i don't know where to start. I can get the top part hooked into the cage but how do u get the bottom. This is the piece i am on about-
Small Pet Tubes : X-PART Ferplast Network Attatchment : www.EquineCanineFeline.com the place to buy all your Pet Products, Horse Products and Pet Supplies online (http://www.equinecaninefeline.com/catalog/x-part-ferplast-network-attatchment.html)
you push it through horizontally through the gap then fold it down and it 'hooks'..but then how does the bottom fit? I tried but it nearly snapped!
Also do you cut the bars first or after?
thanks xxx
The new cage is all set up and now i just have to attach the piece to his wire cage.
Problem is i don't know where to start. I can get the top part hooked into the cage but how do u get the bottom. This is the piece i am on about-
Small Pet Tubes : X-PART Ferplast Network Attatchment : www.EquineCanineFeline.com the place to buy all your Pet Products, Horse Products and Pet Supplies online (http://www.equinecaninefeline.com/catalog/x-part-ferplast-network-attatchment.html)
you push it through horizontally through the gap then fold it down and it 'hooks'..but then how does the bottom fit? I tried but it nearly snapped!
Also do you cut the bars first or after?
thanks xxx